Whilst not in Step record mode …
.
Press(hold) Fill(Page)
Press(hold) Yes
Release Fill
Release Yes
.
Now Fill is latched - press Fill again to unlatch
.
This is poorly described in the comments of the Elektron video just released
Whilst not in Step record mode …
.
Press(hold) Fill(Page)
Press(hold) Yes
Release Fill
Release Yes
.
Now Fill is latched - press Fill again to unlatch
.
This is poorly described in the comments of the Elektron video just released
Great ! Now I have to update - no PC at home …
interesting bug/feature/trick
what’s the benefit of this over direct jump to another pattern?
A feature, I’d suggest. Benefit being extra flexibility/hand and patterns !
Hi,
I tried to latch the fill mode as described, but nothing happens. Moving the data entry knob D has no effect either.
Do you have any clue what I’m doing wrong?
have you set TRCs normally and used them normally
the latch should just make holding that page button down easier
pay special attention to hold, hold until release
must try again in case it’s changed, but it was fairly easy iirc
Hi,
I tried to latch the fill mode as described, but nothing happens. Moving the data entry knob D has no effect either.
Do you have any clue what I’m doing wrong?
You’re evidently not even using TRCs at all
You need to Hold a trig down in step mode, then p-lock a TRC condition to that step (if you Press trig and tap encoder D down it will lock a Fill condition)
Try using those first, then test latching mode
Thank you for your quick reply.
Meanwhile I figured it out. It differs from your instructions.
Not that i can tell, but glad you’re back in the room
still good!
Using the COPY PAGE command to latch the fill.
Brilliant!