Digitone 1.10: bug discussion


it is, yes. Was grid entered, not played in.


yes, only on first occurrence


Try nudge it a little bit after “on grid”


This is a known bug on the digitakt as well. Starting the dt or dn from any external source can cause this to happen. There are a couple of threads addressing this. But the most popular workaround until it’s fixed is the one mentioned above to nudge the first step forward slightly.


Are you starting the sequence from a DAW?


Octatrack. Working fine today. Very odd!


Whenever stuff like that happens to me i chalk it up to user error :slight_smile:


Ha, as would I normally, but I didn’t change anything!


I think the effect knobs while at external input page send some kind of midi cc data.
I connected digitone midi out to an external synth (cheetah ms6, modded to take cc) and ms6:s audio out to the digitone ext in. When adding chorus/reverb/delay to the external in signal, it also changes the sound on the synth.


I’ve noticed a couple of times when being quite active with various controls from a performance level that I’ve had a couple of different issues.

If un-muting a track and reload pattern at the same time on a couple of occasions it has seemed as if the function button is held down once released as pressing record, play or stop copies, clears or pastes respectively. Only way out was to power cycle.

In a similar fashion when using multiple encoders to change values I got a total freeze out where the current sound hung constantly, the controls stopped working and the screen was looking half refreshed and also frozen. Also had to power cycle.

On the whole the machine seems very stable but doesn’t seem to like being pushed on occasion.


Bummer, I’ve never had this issue with either digitone I own and I constantly max out layering, voices and parameters. Have you tired factory reset?