Hi Peeps
I checked the forum an the manual but couldn’t find an explicit answer. I assume that this can’t be done but thought I’d check.
I am sequencing a synth an set up CC’s for cutoff, resonance etc an all works fine. However I want the CC’s to be sent without being tied to a trig - an example is that I have set all CC’s an have a nice starting patch but I still want to tweak it so I don’t want the CC’s being constantly reset by being tied to a trig. The problem is when I power cycle the CC’s are still there but only send to the synth if I turn each encoder. Hope that makes sense?
@sezare56 I assumes you must know ???