Analog Rytm midi notes

[redbongo]

Hello Elektronaughts!

If you. please, Is the Analog Rytm capable of transmitting notes via midi cable to external synths?

[Octagonist]

@redbongo

If you. please, Is the Analog Rytm capable of transmitting notes via midi cable to external synths?

Yes.

Each Track can send MIDI on it’s own channel. The routings are defined in the config [FUNC]+[FX] (Midi Config) -> [Channels].

You might need to turn the feature on. I can’t remember how right now.

[xidnpnlss]

Yes. Note, length and velocity only. Manual pg 43

[redbongo]

Thank you for your fast response!

I have always used the Rytm “stand alone”. Recently added the Moog Subsequent 25. I believe the two working together will be a very good instrument for the music I compose.

Thanks again!

[joris.roling]

Only notes, no CC’s from tracks, right?

[xidnpnlss]

Correct. Note, Len (which I think is the Hold parameter) and Vel only.

[avantronica]

@redbongo

capable of transmitting notes via midi

yes, mono, but only over a predefined (lowish) range which aligns with the AR sequencer’s 4 octave setup

Midi note number 12-59 if playing pads
Midi note number 12-60 if manually sequencing p-locks

Analog Rytm OS 1.50A: bug reports

The default Pad Midi Note is 36, the lowest pad is 12 and the Highest is 59 (it’s not a C) The Lowest Sequenced note is 12 and the Highest is 60 (it is a C @ +24 , pads only reach +23) There is no fixed standard, there are a couple, about how to reference these Notes against a designated ref C - some start at C0 some at C-2, so it’s best to look at MIDI number which is absolute It is nonetheless very much loaded in the lower half of the MIDI range, the Notes 0-11 are reserved for playing The…

[daphnids]

Hey y’all so I just started messing around with using the Rytm for midi sequencing to use in live sets and for some reason the notes are coming out like 2-3 octaves lower than normal. For example, the highest the midi notes go under the TRIG page is C5, but C5 is like a C2 or C3. I’ve tested this with my TX81z as well as Assimil8or with Locutus, same results both times

Has anyone else encountered this? I have the latest firmware and can’t find other mentions of it.