Hey y’all, as described.
Elektron Digitakt:
Latest OS
USB Config on Overbridge
Overbridge:
Latest version
Drivers enabled in Security
MacBook:
Catalina OS, tried two different MacBooks, both won’t connect (and both will connect Transfer with Digitakt).
Any advice?
Update:
Checked the following link — I do not have anything blocked in “Disabled Software”
I am confused why I am able to see the Digitakt in Transfer but not in Engine/Overbridge.
USB not being set to overbridge mode would be my guess, but you said that is set.
Is the USB straight into the Mac or through a USB hub or anything like that?
Yup, Overbridge mode per settings is selected. USB straight into the mac. It’s also connected in System Information (screenshot below)
Elektron specifies the USB cable should be plugged in already when you turn on the DT. Did you do it in that order. I’ve definitely seen some funky OB behavior when I didn’t follow that
Yup — I keep the cable plugged in during my workflow. At this point I’ve tried restarting with and without cable plugged in 
