DT2 Delta Time Between Triggers Is Inconsistent

[ripsaw]

I sent support a link to this thread. I doubt it will help any.

@djenzyme

DT1 has only one DSP chip and DN1 has two. On release, Elektron stated that the DTII runs on a newer platform than gen1 digis.

See this thread:

The new elektron platform(s) - DT2/DN2 vs Tonverk

Well, here’s a proof Whereas the Tonverk is based on the ARM architecture (just like modern MacOS computers and smart phones for example), the Digi line (and probably all the other Elektrons prior to TV) is based on the Coldfire / 68k architecture. [image] So TV and the digi line are both different architectures and platforms. Digis do not have an “abstraction layer” and run “bare metal”, so very close to its hardware but with full control over it but they are also “harder” to…

TL;DR same CPU used on the DT/DN/DT2/DN2, the DT2 added a DSP chip and the DN2 doubled up the CPU. TV using different platform completely Linux, verses the bear bare metal of the DT/DN/DT2/DN2

and also note that I bug I reported about the DT2 also existed in the DT1 (same codebase was used) and they fixed it on both.

See this thread:

@ripsaw

Edit: setting the depth to 0.01 and the initial condition to REV cycles between REV and FWD

@ThomasJ

Yep, and this is not correct. The intention is to use the MOD depth on PLAY MODE just like it works on SLICE etc.

@ThomasJ

For completeness, DT1 OS 1.52A is also out, fixing the modulation issue regarding Play Mode.