Bug: Kit Samples Switch On Their Own Using Overbridge

[B_LD]

@IronCobra

• Operate the AR unit as normal. Power OFF/ON the unit as normal. At this point, there is a chance that immediately following powering the unit on, the samples in the active kit become swapped with other random samples within the +Drive. This can also occur with src engine parameters, but is less frequent.

Hi! Not sure if this adds anything useful, but something that appears to be very similar has been reported before for A4 and AR.

AR 2 new project after load playing previous project sound

Hi, Usually I would not post something pertaining to another machine, but as the same bug happened to me (and someone else) on my A4 MKII, maybe it’s relevant. Maybe in the last firmware for flagships (AR & A4) something linked to the way projects are saved has been messed up? A different take: If you’re using samples those take a little longer to load on the AR and can therefore lead to project sounding incorrectly the first few seconds if played right after loading.

Analog Four/Keys OS 1.51: bug reports

Not sure if it’s been mentioned before but when I power off the machine then on again (hours later), sounds are often out of place (one time I had what seemed like sounds from an adjacent project, another time it’s just my last tweaks that aren’t saved, LFO, etc). I have to save a kit for any pattern I make a modification in or it’s at risk. Maybe it’s just me misunderstanding kits. Edit: can’t reproduce for now. Must have messed up a kit myself.