Hey there,
I’m using a MIDI device (Bamboo M, from the maker “Music of The Plants”) to send midi signal in my Track1.
The other tracks are playing drums, pads and other stuff.
While the MIDI device sends signal, everything works just fine.
But when the MIDI device stops sending signal, all tracks stop. I have to relaunch by pressing PLAY again, and again.
I don’t understand why. Any clue ?
Is it sending a transport stop command?
After digging in the MIDI menu, in MIDI EXT, i found TRANSPORT setting.
It was set to “etx”. I tried to change to “int+ext”, and to “int”, but it’s still the same.
I checked the MIDI SYNC settings also. There is TRANSPORT RECEIVE, and TRANSPORT SEND. I tried checking, unchecking, both or either. problem not solved yet !
Try disabling clock receive in the sync config.
1 Like
Thank you. I tried but nope.
I also tried to check or uncheck everything. No noticable change, everything just plays at it was.
Ok so I fixed it.
In MIDI CONFIG / PORTS / i unselected RECEIVE CC/NRPN.
Thanks for trying to help, I deeply appreciate it!
1 Like