This one really warps my brain, maybe one of you can help me out here?
I try my best to explain:
I have the DN connected to the 1010music Blackbox.
i have setup one miditrack on the DN to play slices on the blackbox, and 2 midi control knobs on this DN MIdi track to control pitch & filter of this slices (via midi learn on the blackbox, twiddling the knobs on the DN and voila i can control these parameters)
This works , i can play the slices on my DN, and i can change the pitch and filter by turning the knobs.
So far so good.
BUT when i now record a sequence of this on the DN, the slices play allright, but the changes in pitch/ filter are not there!
I just hear the same pitch/filter setting like i set it to the last time i twiddled the respective knob on the DN, but not the recorded changes!
The yellow paramlock triggers are there in DN’s sequence indicating that it did record the param changes.
I just don’t get it.
I can turn the knob and hear the sound change.
i can record this knobs parameter changes.
but the recorded changes dont play, even though the slice triggers in the same equence play just fine!
What the hell where is the problem here??
EDIT:
SOLVED!
ok i solved it.
It was a setting on the Digitone.
For everyone who may have the same problem:
Go to your Digitone Settings -> MIDI CONFIG -> PORT CONFIG -> ENCODER DST : INT
(mine was set to INT+EXT causing the problem.)