I’m trying to set up Maschine Mikro 3 to use as a midi controller in cubase for finger drumming… I don’t even want to use the maschine software. I installed the Mikro setup program but all the happens when I plug the usb cable into the Mikro is a sweep of rainbow LEDs across the pads and then the tiny oled screen stays lit. I press shift and the star button top left (and the other two) but nothing happens. I didn’t have this problem previously but I had to do a fresh install of windows 7 a few days ago and I’m having to put everything back on and because I’m getting old I can’t remember what I did last time. I put in a support ticket with NI but that could take days to resolve. Can anybody advise as to what I’m doing wrong? I can’t actually see any drivers for the Mikro 3 on their website, only drivers for Mikro 1 & 2. Confused.