OXI ONE AS 303 SEQUENCER
Hi folks,
I have created config for a CV sequencing of a 303 including accents and slides.
I have spend a good half day on it ![]()
I was wishfully thinking it would be possible to do it with velocity only and it would work like this:
0-32 normal
33-64 accent
65-96 slide
97-127 accent+slide
That’s unfortunately not possible (I think).
I have however been able to execute the idea via a single MOD lane.
With the config detailed below, the grid lanes in the mod sequencer correspond to (as pictured above):
5 - Accent
4 - Normal
3 - Slide
2 - Accent + Slide
So you put notes in the track sequencer and then open MOD lane, where the amount of modulation determines in which of the four states mentioned above a given step plays.
Below are precise settings for correct alignment of the visual feedback with the actual sound modulation (no matter whether you dial in changes via global encoder or via grid buttons).
Velocity of the notes in the sequencer must by set to 65.
CV 1 Pitch:
→ CV In
Gate 1 Trig:
→ Gate In
Gate 2 (Accent - lane 5):
Src Mod1
Trhld 61
→ stackable cable into Accent In
Gate 3 (Slide - lane 3):
Src Mod1
Trhld 87
→ stackable cable into Slide In
Gate 4 (Accent - lane 2):
Src Mod1
Trhld 104
→ regular cable into stackable cable inside Accent In
Gate 5 (Slide - lane 2):
Src Mod1
Trhld 104
→ regular cable into stackable cable inside Slide In
MOD1:
min 0 max 127
INT DEST: Vel
INT OFF: 65
INT AMT: -100%


