answers based on my own borked original OT CF card and MK1
-
- yes. card failure means OT cannot load files and everything gets stuck in a state attempting to load a project. card is detected, OT boots up and tries to load the last active set, but due to card failure it endlessly reads and nothing loads/progresses — “Card Status” LED gets stuck with green indicator on my MK1 and buttons don’t do anything.
-
- no idea. you can contact elektron support directly link at the bottom of this page. take a look at page 112 in the manual — 8.1 TEST MODE. no one here can help much with a hardware fault / diagnostic. only elektron or your original retailer can help with that. (having said that — NO INT looks like it could be a new MK2 thing regarding the cf card being dead Ata [no int] : CF card issues)
-
- should do / seems like it will based on Ata [no int] : CF card issues. also see page 15 in the manual for allowed disk format options — 3.4.1 COMPACT FLASH CARD SPECIFICATIONS
-
- officially detailed in the manual on page 15 — 3.4.1 COMPACT FLASH CARD SPECIFICATIONS. recommend buying the highest read speed you can afford. don’t be cheap. spend the money. check out this thread for recommendations / discussion Compact Flash - what's best for OT
-
- no, you’ll just need to create/mount a new set on first boot on a properly formatted CF card. see page 23 — 6.2.1 MOUNTING A SET (and the preceding paragraph)
-
- unlikely needs an update. but i’m not official support and i have no idea what ATA stands for. if it freezes during boot up it’s the card usually. replace the card or try demo mode as mentioned above.
-
- demo mode mentioned above, new CF card, contact elektron support at link included above.
none of the above is official support and i accept no responsibility for anything (except for things occurring in my own life but that’s tangential to this topic).