I’d like to setup a mono send from the OT to an effect pedal. Being that there is one left over mono output, is there a way to still maintain cue functionality even if that cue signal is mono? Thanks!
The Cue outputs are a stereo pair - so if you took the signal from one to use as a send it would be either the left or right channel only, same goes for the remaining cue output. There’s no way to route audio to only one of the cue outputs other than by hard panning it - so I don’t think you could use it the way you’re describing (unless hard panning it works for you).
1 Like
Yurp, I think you just pan the track using amp balance 
Thank you both. I think panning should work!