Isn’t the Machinedrum becoming a MonoMachine light with envelopes, new GND waveforms and neighbours? What would it need more, to go further into the MonoMachine territory?
Pitch data as modulation source, filter pitch tracking, arp and per track delay.
And a properly working CTR8P like mentioned above
Play GND waveform via MIDI.
user error or bug
im trying to LFO the NOTE param on a MIDI track. doesnt werk.
I always assume im missing something…but there isn’t much to mess up here.
thanks
DANG…I remember seeing that a TIME ago. didnt recall it.
thanks man
Adding: I screen capped that and added to my manuals folder
Hi Folks,
Here a bug, (whose not in the X.04 version)
When use the MD in song mode, the Program Change doesn’t work anymore. (send a PC information but just 00 value.
If you don’t use the song mode it works.
Strange
Thanks !
Did you try X.07 ?
yeah i’m talking about the 0.7x version.
Hi gang. Sadly I’m getting lots of freezes with version 7. I only have external clock coming in. Is there a way to disable midi map? Anything else that might be causing a freeze with external sync?
Thanks for all your hard work with this Justin and team!
What’s the source of the clock ?
Master is Deluge out running into Monomachine thru to MDUW mkII.
Running into a bit of a nightmare scenario after attempting to upgrade to X.07 from X.05c. After sending the update via sysex, I’m getting a red screen of death. I can still access the boot menu but only sometimes and I’m seeing glitched pixels on the screen.
I can sometimes access the MIDI upgrade screen but when I try to send sysex via SysEx librarian, the random trig buttons light up and the machinedrum freezes.
Any advice on how to fix or where I can send to for repair? Thanks.
Battery?
I’d be surprised if it was the battery since it was working fine right before I attempted the upgrade.
Likely a coincidence you’re seeing it during the OS upgrade.
a battery can just start quitting.
happens to my damn mouse all the time
@JustinValer sounds better tho
Just replaced the battery and my MD is working again, guess it was just a coincidence that it went as I was upgrading. It even booted up the new firmware so I guess it was able to transfer even with a dead battery.
Thanks so much for the help everyone, now it’s time to dive into the new MCL manual and get rockin.
have you noticed the same thing?
my Best