Does anyone know if its possible to sequence and external device (eurorack) with the machine drum while its connect to the mega command .
Thanks
you could use impulse from the MDs CDEF outputs, or midi from mcl
2 Likes
Thanks. So could I use a MIDI machine on the MD x0.7 send midi to the MC and then out from MC to my MIDI to CV converter?
no, currently MID machines are not available when in enhanced mode.
MCLs 6 midi tracks are intended for the purpose you’re after.
2 Likes
How can i use them? I want to use some of the external sewuencers of the mcl but i couldnt find out how. I was reading the manual but its not giving lots of info.
MCL 4.60 enabled the MID machines again. So you have both options.
1 Like
Ok but how do i use the ones in the mcl? The manual was not helpfull. Is there something like a more advanced manual for the mcl? I know the old way wirh the midmashines but i dont wanna use a machine for that. Right niw i do my external midi sewuencing with my analog keys. 2 of my ak channels are used for that. But if possible i would like to use the mcl to control 2 midi channels i send tonmy eurorack.
You can do all this.
There is a bit of routing and midi setup to do.
1 Like
How theidi routing works is covered in the manual. My question is how do i access the external miditracks.
Found a newer manual where its covered. Still i got some priblems with the y grid i will probably stop using it and just connect my analog keys for the keyboard. When i make changes in the y grid it doenst appear on the sequencer of my analog keys. Should it be like that or should the ak sequencer show the information from the y grid.