Is possible to LFO start when pattern load? because I feel that the LFO is always random, I thought Start Phase parameter would be triggered on pattern load.
I got better results using FREE mode since I dont see another option 
You can plock the first trig to the “trig” setting in lfo instead of free to make it start at the same position every time
1 Like
Thank you Dan,
I put trigger1 with condition 1st and LFO retrig, but than we loose the note of trigger1 for next sequences since is with (1st condition).
the thing is that we dont want to retrig LFO every time that trigger1 is readed, only on pattern load.
We are needing this update for the next firmware?
LFO retrig on pattern load? 
put a 1st TRC on step two which is nudged fully left and set the trigless lock to reset phase or even correct phase to where it would be on the step it can be accommodated -then teh phase is reset once upon start, it could be glicthy - otherwise just delete the parameter lock after it starts is an option