Hi! Spent a few days on it, maybe you could explain it to me.
I want to make an arrangement in DT song mode controlling OT tracks (muting/unmuting them). In order to do so I wanted to assign DT midi tracks to channels 1-8 and then make OT tracks recieve sequence from DT. I did go to OT settings - midi - channels and and made sure that trig ch is 1-8 but when i hit play trigs are not making sound. Am I doing it wrong? Is there a way to make it work? Because it works great vise versa OT programming DT tracks through midi tracks I thought there should be a way to make it work the opposite way
Did you set right notes and channels on DT midi tracks ?
(Notes C6-C8 on DT correspond to notes C5-C7 on OT).
In MIDI > CONTROL you can choose STANDARD, or FOLLOW TM (Trig Mode).
This way you can choose Chromatic, Slot, Slice mode…
3 Likes
My sequence on DT was in C5. I changed it to C6 and it worked. Thank you so much!!
1 Like
Were you able to get the Octatrack to send the correct notes to Digitakt when using the Tracks trig mode? When i hit the buttons 1-8 on OT it plays the corresponding track on DT, just several octaves too low. Can’t figure out how to change the note sent out.
When in enable the midi channel in OT for a midi track, it also stops Tracks trig mode from sending the notes to DT.
maybe the auto channel in the midi settings?
I think the channels are fine as the note event is sent and received. Problem is the note is several octaves too low, and after reading manual I still don’t see how to change the note sent from OT via Tracks trig mode (i.e. not chromatic mode, slices, etc).