After selling my Digitakt late last year I had to get a new one. I missed it too much!
However, the Digitakt I bought is not connecting to anything via USB.
I have tried connecting to two Mac OSX (10.13.6) computers and a few iPads (iOS12.1.1)
I am unable to make a connection to the transfer application (v1.1.0) and I don’t see the device in my Audio Midi Set Up.
The unit came with a Grey USB cable, unlike my old one that had a red cable.
The Digitakt is OS 1.10
I am able to connect via Midi to other midi devices.
I have also checked that the mid Config settings are set to Midi + USB, and have also tested on USB only.
Here is a listing of the settings in the Midi section:
Synch
- Clock receive: Off
- Clock Send: On
- Prog Ch Receive: Off
- Prog Channel Send: Off
Port Config
- Turbo Speed: Off
- Out Port Config: Midi
- Thru Port Config: Midi
- Input From: Midi+USB
- Output To: Midi+USB
- Output Ch: Auto
- Param Output: CC
- Encoder Dest: Int
- Trig Key Dest: Int
- Mute Dest: Int
- Receive Notes: On
- Receive CC/NRPN: On
Channels
- Track 1 -> Ch: 1
- Track 2 -> Ch: 2
- Track 3 -> Ch: 3
- Track 4 -> Ch: 4
- Track 5 -> Ch: 5
- Track 6 -> Ch: 6
- Track 7 -> Ch: 7
- Track 8 -> Ch: 8
- Track A -> Ch: 9
- Track B -> Ch: 10
- Track C -> Ch: 11
- Track D -> Ch: 12
- Track E -> Ch: 13
- Track F -> Ch: 14
- Track G -> Ch: 15
- Track H -> Ch: 16
- Fx Control CH: off
- Auto Ch: 14
- Prog CHG in Ch: Auto
- Prog CHG Out CH: Auto
I have factory reset the DT.
I do not know what else to do at this point and hope that you can help me.
If anyone has any other advice I would be all ears.
Thanks