I Purchased a digitone today . I updated the latest firmware and used it for about an hour with no issues.
I have gone to turn it on the second time and it is crashing on the load up screen . Won’t go any further than the elektron cymbal on the start up.
I have tried power on / off and power supply out etc with the same out come every time .
Can any one offer advice ? It’s Pretty annoying
Thanks
You might have to return it to where you purchased it.
Whats happens when you hold FUNC while powering on? Can you access this “preboot/bootloader menu” ? If yes, you can try to flash the FW, maybe that helps…
Hey, whats the outcome of this?
I was ready to send it back it suddenly stopped doing it .
It hasn’t crashed in over a week now . I did swap power supply’s so maybe this stopped the issue ?
I am going to monitor it closely
this happens for me when I power cycle too quickly. iirc in the manual it says to at least wait a minute or so between turning it off and turning it back on. could be your issue.
it was doing it after being left for hours. But thankfully it seems to have stopped !