Hi all,
I’m trying to use Logic to sequence my Digitakt as well as other samplers/synths. But when I connect up the Digitakt, whether I use DIN or USB, after a few minutes the sound completely cuts out. It’s still connected, I can see the pads being triggered, but no sound. Even if I physically press the pads.
I can restore audio by switching to another pattern, but eventually it will disappear there, as well. And even when I disconnect the Digitakt from my computer, those patterns play no sound until I do Reload from Proj.
I’m assuming Logic is sending some CC or Sysex command that is telling the Digitakt to silence the outputs, but I can’t imagine what that would be or how do disable it.
Any ideas? This is totally killing my ability to create here.
Thanks.