@krunchr @jaw
You can set the DT’s MIDI parameters to send these messages.
On the AMP page, set one knob to MSB and one to LSB (I think these are CC 6 and 38 but you might need to double check this - they are actually labeled as MSb and LSB in the DT when you get to the right one so shouldn’t be too hard to find)
On the FILTER page, hold FUNC + press the encoders that match up with the ones you set on the AMP page, to enable them. Then set them to whatever MSb and LSB values your equipment needs.
Can’t comment on your specific equipment and you’ll probably need to mess with it some until you find the “magic numbers”
I had to do this to send program changes to the Roland MC-303, but one of the numbers was off by 1, I forget which, but say for example in the MC-303 manual it had something listed as “bank 1, sound 30”, I had to send like, bank 0, sound 30, or bank 1, sound 29, I forget which was off, but something was off. Also not sure if it was because of quirks in the MC-303 implementation or in the DT, or just a difference in approaches since decades have gone by
Just last night I was experimenting with sending NRPN to my Micromonsta, that was even more tricky, but finally had success, so all the MSB/LSB/NRPN stuff is definitely possible