If I try to change the pattern to any other pattern than A01 I get the following message on the guy. (see picture)
A01<A02
and the pattern does not change. (I always see the same trigs as in pattern A01.)
Can somebody tell me how I can fix this. (I just want to be able to switch between patterns… )
Try with a new project.
Did you change Scale Setup ?
The display seems normal.
i think I did something on the scale set up… individual track length.
but what seems not normal to me is the A01<A02…[quote=“sezare56, post:2, topic:34789, full:true”]
Try with a new project.
Did you change Scale Setup ?
The display seems normal.
[/quote]
The display is the same for me.
It could have been A01 > A02, I agree. Not a big deal.
Check Master Scale.
Look into the pattern chain options. Right now it’s probably set to change after pattern length, and with a master length of inf this never comes around. Set it to 16 or something and see if that helps. Sorry, can’t remember where this menu is located off the top of my head!
thx you guys, i will check it this evening.
it s on scale setup
master lenght of inf (before 0002)
this was it. thx!
totally agree with the direction of the arrows
