Using AR as an external fx processing unit

mendi_sahil · 2015-02-04T20:53:28.000Z

how does one get the AR to read an audio signal through the audio in port at the back(next to the stereo outputs). i thought that should be the simplest thing but couldn’t figure it out. anyone?

avantronica · 2015-02-04T21:00:24.000Z

plug in an insert cable and hook up source (or any stereo cable to suit). Done. That’s it, you can use some of the distortion and the compressor !

Clic · 2015-02-06T13:35:53.000Z

If you look at the schematic pic in the manual (p 6): The external input just runs throug the compressor, nothing more. What I find a kind of a pity anayway…

Is this to be fixed with a software update?

avantronica · 2015-02-06T13:46:46.000Z

""Clic"":

If you look at the schematic pic in the manual (p 6): The external input just runs throug the compressor, nothing more. What I find a kind of a pity anayway…

Is this to be fixed with a software update?

as i mentioned, it also goes through a part of the circuit shown on the distortion page (the sym) - best to set up some compression first then adjust to audition
.
prob not !

Clic · 2015-02-06T13:52:22.000Z

? How come? See:

2015_02_06_14_51_57_Analog_Rytm_User_s_Manual_GESCHUeTZT_Adobe_Reader.png1101×278 26.7 KB

avantronica · 2015-02-06T13:59:18.000Z

well, they have the delay ‘grit’ knob in there and the pre filter ovd knob is in the amp page - some things don’t fit in the UI or tie up with the diagram, just laid out that way as a compromise, but the SYM indeed works on external - there’s more on this in another thread … !

perhaps the magic happens here

4444.png1101×278 37.9 KB

Edit: Or just after ? according to this thread …
http://www.elektronauts.com/t/dist-sym-control-noise-floor-panning/8520/78496