Update to 1.40c → no sound

abluesky · 2023-10-25T12:45:00.548Z

I just updated to 1.4c. There was some sound at first but now total silence. Tested via the headphone out and overbridge. Stumped. Any ideas?

shigginpit · 2023-10-25T13:07:22.637Z

Unhook from overbridge. In standalone, go into the settings menu check the settings for global audio routing, especially “int to main” and “usb to main”.

You can also check audio routing at a pattern level by going into the pattern menu and under routing verify that the box is checked for “use global setting”.

When all else fails, make sure you aren’t plugged in to your computer then power off for 30 seconds, power back on and check again. Sounds like something got turned off in the global routing menu though.

image877×867 126 KB

I’m not on version C but I assume the menu trees from the manual haven’t changed.

Also, even if the setting looks correct in the audio routing menu, assume that something is wrong so for example if it says auto, change it to on or off just to make sure the machine knows that something has changed before you set it back to auto or on. I know you aren’t getting audio in overbridge, but I read about someone’s digitone getting stuck in overbridge audio mode and it didn’t register on the menu level, I just can’t remember where I saw it.

abluesky · 2023-10-25T18:50:00.558Z

Thank you. .

shigginpit · 2023-10-25T18:59:07.392Z

Yup. Hope that works out for you.

Bryan_T · 2023-10-25T19:26:32.221Z

The one time my Digitone had no audio it was because I had accidentally switched to MIDI tracks. I was very puzzled until I realized what had happened.

abluesky · 2023-10-25T22:49:12.422Z

Thanks everyone. Got it sorted.