I just updated to 1.4c. There was some sound at first but now total silence. Tested via the headphone out and overbridge. Stumped. Any ideas?
Unhook from overbridge. In standalone, go into the settings menu check the settings for global audio routing, especially “int to main” and “usb to main”.
You can also check audio routing at a pattern level by going into the pattern menu and under routing verify that the box is checked for “use global setting”.
When all else fails, make sure you aren’t plugged in to your computer then power off for 30 seconds, power back on and check again. Sounds like something got turned off in the global routing menu though.
I’m not on version C but I assume the menu trees from the manual haven’t changed.
Also, even if the setting looks correct in the audio routing menu, assume that something is wrong so for example if it says auto, change it to on or off just to make sure the machine knows that something has changed before you set it back to auto or on. I know you aren’t getting audio in overbridge, but I read about someone’s digitone getting stuck in overbridge audio mode and it didn’t register on the menu level, I just can’t remember where I saw it.
4 Likes
Yup. Hope that works out for you.
The one time my Digitone had no audio it was because I had accidentally switched to MIDI tracks. I was very puzzled until I realized what had happened.
1 Like
Thanks everyone. Got it sorted.
