Hi to All!
Excuse me for bad english …
I Have an Octatrack OS 1.25
I can’t send AB or CD input to CUE.
I open MIXER and press CUE + A-B or C-D
but the sound stay on the master track …
I dont know why …
Help me!
Thx
Regards from Italy
L uscita cue reindirizza il segnale ma non lo esclude
Devi mettere in mute i canali dell’ot ed attivare il cue cosi senti il segnale solo nella seconda uscita e non hai la sovrapposizione sul master
Ciao 
Mmmm, it’s not possible to route incoming audio from AB or CD to Headphones output?
Regards!
Edo
yes, if you press cue and recorder button ab or cd… the red led fashed and cue output is activate
remember to balance the output headphones, between master and cue
if you use it on master not feel a thing
if you use it in the middle you will hear 2 overlapping signals
Thanks!
But i want to route AB to cue and exclude them from the master output …
It is possible?
Hey Alteredward,
I was able to get an input to route to either of the cue outputs without the sound going to the master by the same instructions as you: CUE + A-B or C-D
When I changed the “DIR” setting for either input to be more than 0, the input signal went DIRectly to the master out, could that be your issue?
(I was reading a section in the manual called “MAIN AND CUE OUTPUTS ROUTING”
I also searched the manual for “cue out” also, the results cover most of the menus that affect the audio routing, like the cue out config in the Project -> Input -> Audio menu and the MIXER page. )
I hope that helps!
No way to “mute” external input on the mixer track?
Thx
Yes, set direct input AD CD as 0 from mixer page
You can pre listen with cue and sampling in a track without signal through in master
hello i seem to have almost the same problem. i put in my 303 clone xoxbox to the input A/B but i only get sound to A and if i swich the splitcable it only comes sound from B. WHAT Should i do please help i want to record my hardware so bad !!