I have a track in my DAW that is a somewhat dynamic arp. It starts on B, then goes up a few notes, then down to D#, then up a few, then down a few, so on and so forth. I tried programming the notes into the MnM using the arp and the CYCLE feature, with each trig having the 4 notes that are proper for the particular section. The first trig runs properly, but the 2nd one does not because the CYCLE runs from lowest note to highest even if I didn’t program the “chord” in that way. I recall there being no way to PLOCK any arp settings, so I’m wondering if there’s a workaround to this.
The reason I have to use the arp is because the original melody is played off-step and I can’t just program the trigs properly in the MnM without changing the timing of the pattern, which then throws off all the other tracks in the same pattern.