Hello. i think it bug, but i not sure. so want to ask any help
Trig with KICK going on so small volume after i reload DT2 i check everything.
nothing mute
sample stay on the same place
volume trig stay without any changes after last save
but no matter what I do, the trigger volume always remains very quiet
at first i thought there was no sound and the sample was gone
but in fact it just plays very quietly and i can’t make the volume higher
Hmmmm… the other day I had a sample on Trig 1, it was muted, the button was flashing for each trig but when I unmuted it I didn’t hear anything. I assume no sound but maybe it was just very very quiet. Anyway I couldn’t get any sound out of it. I turned off/on and presto everything worked fine. i hadn’t changed anything as it was the beginning of my session and had just loaded the pattern. I do not believe I ever entered trig mode or did anything else dumb (and having Elektrons for years now I am fairly ok at troubleshooting).
i will check velocity before also. no it problem not in velocity
velocity show ok. level also ok, sample play and show on screen played ok
but volume so much small and i cannot made bigger
so for now i solved problem only reload DT2 and clear track abd after put sample again one more time. but with this options all my config from last session lost for filter amp effects and i need made this work again. so it not ok.
because tome by time it happen and this mean every time i need made allot of work one more time
did you try off play and check this 1 trig with mamimum level on it ? because my sample not lost. lost only volume and i cannot fix and up volume more. but i hear sound when put vol trig on maximum.
yes i use it, but before when i work with pattern i save it with all config and compressor also. all work ok , so after on / off all must be stay on same places and not change. and it happen 3 times already
I have had similar problems several times and I also can’t find a solution.
After saving the project and rebooting the synthesizer, I get such problems
1/sometimes the sound of the first Kick trigger just becomes very quiet and I can’t change its volume settings - it’s still quiet. There are no problems with velocity. There are no problems with the compressor. Sometimes this problem disappears after rebooting - sometimes it doesn’t.
2/ More and more often I notice that the triggers change places after rebooting the synthesizer. I add a sample to trigger number 3 (can see on my photo)
I’m not going off-site to check your video, but whenever I see people mention a Kick not working on Trig 1 I put a little money on it being a resonant filter kick
Does the kick play fine on the second pass - if so, you may need to adapt its settings