Transition trick phase problems

Groof · 2015-05-08T18:27:04.000Z

Hi, this is my first post in the forum. I have a problem when doing the transition trick with the crossfader, the recorded loop and the live sound turns flangered when i put the fader on the middle zone and its imposible to do a slow transition between… Any ideas? Cut the lows using EQ or Filter doesnt work

Groof · 2015-05-09T09:13:29.000Z

https://youtu.be/ZBANTG8lWVw Project downloaded and the same problem … Im using Octa and Analog Rytm…

Groof · 2015-05-09T09:15:35.000Z

If i use two loops instead of one loop and the Rytm the transition works fine…

maass · 2015-05-09T14:58:23.000Z

who is the master in this setup. If it is the AR, try to use the OT as master…

Groof · 2015-05-09T17:09:34.000Z

I will try again with the OT as master , thx…Maybe with the microtiming i can sync the loop better…

JSZ · 2015-05-09T20:03:43.000Z

I think the cause might be that the output of the AR is not consistent. Not that each cycle of the loop wouldn’t sound the same to a human, but it’s not a sample accurate reproduction, like a sampled loop is.

Groof · 2015-05-09T21:54:23.000Z

Good point! Im using a mixer i will try without it…mainout of the Rytm directly to the ins of the OT… Thx.a lot!

Open_Mike · 2015-05-09T22:01:05.000Z

Do you have delay compensation enabled?

Groof · 2015-05-09T22:29:14.000Z

OT as a Master, Turbo Midi On and no mixer used: Same problem… Anybody with OT and Rytm had this problem or it is just me?

Groof · 2015-05-09T22:30:41.000Z

Delay compensation is ON

Groof · 2015-05-10T16:30:47.000Z

Solved! The problem with phase its only with patterns (Rytm) with the same percusion samples no problem with different ones. Thx a lot for the replies!

AdamJay · 2015-05-10T16:35:07.000Z

""Groof"":

Solved! The problem with phase its only with patterns (Rytm) with the same percusion samples no problem with different ones. Thx a lot for the replies!

I reckon a little bump on the overdrive knob here and there on shared samples will remedy that.
Glad it has been solved!

Groof · 2015-05-10T16:58:05.000Z

Yes!! Some modifications on BD and SD does the job.