Let’s not forget about Liberia, even though Myanmar is the real headline
1 Like
Re size: given how elektron have done 4 digi boxes with a lot of dimensions in common, shouldn’t estimates of size be based on obvious commonalities… like front-to-back measurement, centre-to-centre (or edge-to-edge) measurement of encoders A-D or E-H, etc ?
Front-to-back is most likely the same, given a lot of the same buttons in between.
No fader so I won’t think Octatrack. Tone is in the name so I think it as the next generation of Digitone. No page LEDs so does it mean that goes into the tiny display?
1 Like
Can someone start a parallel FAQ thread? 
2 Likes
The phrase translates as “free gas”.
1 Like
time to put tinfoil hat on! 
I’ve looked it up and ended up on some Chinese guitar forum… dunno if related, not much info there though…
1 Like
Looks great but you’re missing the “Drum / Ptn Bank” label
Thanks! I knew i have missed something! 
plz add gentle watermark, would love to see where this render ends up…
2 Likes
In speculative YouTube videos that will give the full scoop about everything we know but you have to stay tuned to the end of the video to hear it, obviously.
like comment subscribe and don’t forget to ring the bell
1 Like
that’s obvious, I was thinking about the websites too…
I think this whole picture is already a watermark 
2 Likes
The two USB C ports arouse my curiosity the most. I dream about a hardware Overbridge host that could act as a mixer.
4 Likes
I wonder what Cue / Edit under FILL does
1 Like
probably same as on rytm, cue the fill, it has the same label too
Press [FUNC] + [FILL] to cue FILL mode for one pattern cycle
the edit unknown… maybe something to do with the Motion/Seq layers
I was drawing a line on one edge of the screen bezel, which I assume to be the same standard as on the other boxes, and then copying the line end to end across to either edge of the Tonverk. Seems like a good technique but I’m struggling with image editor issues, ideally I could do with a ‘ruler’ tool but I can’t seem to find one in anything.
I was able to get a very rough measurement of 284mm for the width, but I’d give a 2cm margin of error for that. The depth was close enough to DT/DN that I’m pretty sure it’ll be the same (176mm).
Edit: Looks like Krita has a measuring tool which will be handy.
1 Like
Ah, thanks
Looks amazing, would have been even better with four inputs (because then I could dump my interface and record/mix everything inside Tonverk)
1 Like
Pfff, not even using dark mode…
3 Likes