Stored patches sound different later(on both A4 and AR!)

nnbveh · 2014-10-11T10:27:29.000Z

HI!

What’s the deal? Some of the sounds i design and store on BOTH A4 and AR start to sound quite different after i turn off and then on the machines, or even just after jumping to another pattern and then back?!!
I can see that all the parameters are the same still, but sound is not! Two latest examples are bass sound on there AR which i’ve made on the BT track, and some pad/chord kind of sound i did on the A4. They both turned into the dull primitive versions of themselves basically, and no, and it’s not my change of perception. All the subtle changes in sound and complexity in case of the pad sound are gone!
I’m sure this happened to me before as well, i just weren’t paying attention to it being new to the elektron architecture, assuming that i was doing something wrong, or that i simply forgot to store my patch, but now i know for sure something is wrong with these boxes…

Anybody experienced the same? Any solution?

Thanks!

bengersfood · 2014-10-11T11:11:57.000Z

I’ve had that happen - no idea why.

Also sometimes on the AR, the first playback of a pattern is very different form all subsequent ones. Again, I have no idea what’s going on.

SIM80 · 2014-10-11T14:40:20.000Z

Yes, this happens to me as well. Most of the time it’s on the first boot up. Some of the sounds don’t sound right even after the whole kit has loaded. Switch to another kit/pattern and then back and it usually comes back around. It’s strange.