1

Recently built the shik N32b to control my OT. but after installing newest firmware and programming the N32b I cannot get it to communicate with my OT.
at this point I think it might not be sending the messages but just want to make sure my OT settings are correct.
can anyone link me to a dummy setting for incoming CC

2

If you don’t have a MIDI interface try it just with USB and MIDI-OX so you can monitor what messages it’s putting out.

3

It works over usb but nothing out of din

4

Have you confirmed that it’s not putting out messages via the 3.5mm DIN MIDI with some kind of interface or do you just have the OT to test with?

Check that the channels are set correctly according to the OT’s MIDI channel settings.