Sampling signal from separate audio interface through Overbridge

Elektron Gear Digitakt
1

Hey guys been trying to figure this one out for the last few days and can’t seem to find a way, so if anyone can help that would be much appreciated!

I’ve got my Digitakt connected to my computer via USB through Overbridge (standalone app), I’m using a separate TC Electronic Konnekt as my audio interface (for monitoring and ins and outs into my computer).

I’m trying to find a way of sampling audio from things that are connected to my Konnekt interface but can’t seem to find a way of routing it into the Digitakt via overbridge.

So for example I’ve got my record decks going into inputs 1 & 2 of my Konnekt audio interface, and I would like to send this signal via USB into my Digitakt, so that I can sample music from my record decks.

I know I could just plug the audio straight into my Digitakt without using USB and Overbridge, but I feel like there must be a way of doing this more conveniently through USB and Overbridge.

I’ve checked these forums but can’t seem to find any solutions or anyone asking about this.

2

I’ve not tried so I don’t know, but…
On the sampling page on the Digitakt, turn knob G to select USB L+R. Then on your computer, route the incoming signals (from your other interface) to go back out, and set the Digitakt as your audio output.
I believe that should work?

3

Yeah I’ve got Digitakt set to USB L+R and I’ve tried setting Digitakt as my audio output (on Audio Midi Setup on OSX) but don’t get any signal.
Not sure if it’s an issue with using another device as audio interface instead of Digitakt.

I was hoping there was a way to set the input in the Audio/Midi settings of the Overbridge app but there’s only an option to select output.