hello i don’t hear my samples when i layer them with my pads and it’s not the volume of the sampes that is turned down
The analog sounds layered with samples can sometimes compete with each other making it difficult to hear clearly.
Did you try turning the volume up for the sample only?
yes i deed
Are you working with a factory kit? It may have been setup in such a way that the way you’ve configured your samples isn’t the way the kit is going to read them.
Have you read the manual? Do you have the manual next to while trying it out? It’s a complicated beast but the manual helps a lot.
Given the 3 posts in this form, it’s either:
- A borked RYTM
or - A case of RTFM!
Is the sample enabled (1) in the Trig setup menu?
no it’s not enabled and all my pads are not muted
Enable it
And please give the manual a read. This particular issue is covered on page 37.