Apologies first off if this has been talked about already.
This is my second Rytm, and I successfully loaded samples into the last machine I had but can’t figure it out on this replacement!!
Driving me mad!
I have C6 installed, and it sees the Rytm and I have the following in config - SDS handshake, Use Extended SDS, and have the Send SPS-1PW name unchecked.
Now when I transfer samples, it says ‘done’ but they don’t show up in the ‘incoming’ folder on the Rytm. I have ensured to make sure I’ve pressed ‘upload here’ on this folder too…?
Having a similar issue. I created a new dir in my Samples folder, designated it as ‘upload here’ and have sent 45 samples to it from C6. I see all the relevant upload progress, but, when C6 is through and says ‘Done.’ only three (of the 45!) samples are listed in the directory
Tried turning the AR on and off but, no joy, still three samples. Disappointing and pretty flaky for such a basic part of the workflow with this machine.
Any ideas? ( NB I was hoping to bulk upload all samples to a new project rather than create kits via SDS )
In this instance I found that creating a folder at the root level of the Samples directory worked; although I’ve no idea why
Also, the samples, as part of a pack, have really long names so will bear it in mind! …hmm, actually perhaps the sub-directory and the long filenames made the amount of characters in the upload destination string too long —dunno, but have had a lot of fun since getting them onto the AR