Hi
I just got my rytm new and created a very modulated (cv , velocity, lfo, scenes , performances and plocked steps on fx track)
On one pattern….occasionaliy at a “busy” point id get like a drop out momentarily ? Like sound breakup…i thought it fould be cross modulation or a conflict msybe caused by mistakenly having the same parameter modulated by two different sources eg lfo and cv modulation?
Or cpu being rinsed!?
Anyone else experienced this?
Id like to know cos i could return the unit if its a failiure
Cheers
Can you share the audio?
Yeah will have to load to insta first its a video.
I checked after video with headphones direct to rytm and was still there.
I did usual and setup new fresh psttern added some fx plocks etc but alot less and no issues but machine had been off for an hour or so by then.
Sounds cool. Not sure what bit you mean is a drop out.
Without knowing a 00:00 time stamp it may have sounded like a nice momentary silence. It’s quite a glitchy pattern so tough to ascertain what’s expected and what isn’t. Also I’m on a phone speaker currently so maybe not best judgement.
Maybe upload the audio then you can give precise moment to focus on?
Its between 15-20 seconds and right at end .
Yeah been destroying patterns lol
Could be the comp getting spiked and pushing everything down?
1 Like
Can I suggest - simplify the area that is dropping out.
You can do that almost instantly under your control and then continue with the track …
1 Like
Yeah @alechko suggested my comp and symmetry maybe to blame so i will look into it , valuable lesson learnt thankyou matey
1 Like
is all the modulation internal or is the rytm hooked up to a daw /overbridge and youre trying to automate using midi cc? because when i first got the digitone keys i tried using bitwig as a modulation source to control it and it made it virtually unplayable, any sequenced events, plocks, lfo’s, ect. would play fine but if i touched any of the knobs or played the keys all hell would break lose. audio dropouts and parameters jumping values suddenly were the two main things, i got in touch with support and they essentially said that its a known issue.
i havent run into any issues with the digitakt so far its the most solid of them but the a4 and the rytm both seem to act up when hooked up to usb, usually the transport stops randomly.
Cheers man but its all internal so i believe its compressor plocks and distortion symmetry causing chaos lol
2 Likes
thats way easier to deal with lol
1 Like
Bingo!!!
1 Like
I had 2 memes about the delay feedback, it’s the most awesome part on the rytm for me, it can be so brutal
2 Likes
Yeah its flippin monstrous… ive been doing the super fast delay time with high feedback its like being hit in the face with a metal tray 