At startup, the RYTM asks to be calibrated (See photo).
This happens every time, even after going through the calibration procedure.
Should i be worried ???
Any ideas how i can stop it popping up?
Thxs
Could be an issue - run test mode - note any errors - then perform the calibration (don’t worry about the 2 hour warning at this stage) and re-test - if nothing is resolved contact support
if test is clear and calibration sorts the warning then allow the device to warm up and recalibrate properly
2 Likes
Thxs
Mine has always done that- I thought it was normal!
Has yours always done it from new?
Have u had any problems with it?
Thxs
Which OS is running on the AR? Has this always happened or is it something that started to happen lately?
Started after a firmware update I think, but everything works normally…I thought it was just a reminder!
1 Like