hello guys
sample on the OT plays until the end nicely decay
same sample on the AR, decay too short, already reset to default all parameters on trig-sample-amp-lfo
need the sample play untol the end…
any idea please?
thanks!
which track is it assigned to? is it being choked by a neighbor track?
it would be your compressor settings.
reduce the ratio (amount) and choose soft knee setting for the easing of transition
use new york style compression, dial the mix to half way
raise the threshold also
if there is a filter for the compressor, adjust that too perhaps?
compressor is on default settings, this is only on the sample playback, synth voice is normal
it is track 11 CY, nothing on neighbor track…
Go to amp page and make sure that hold parameter is set to 1 instead of zero as default. The default setting gives a sharper decay; whereas, a setting of 1 allows you more control of the decay length. I may be wrong but I hope it helps.
I don’t believe the envelopes are quite the same, AR’s definitely geared towards tighter percussive sounds. However, for longer samples I’ll set hold and decay to max and then assign a performance pad to lower their values for a variable decay.