other
1
Hello there,
I am trying to use the Octatrack to control the start and stop of Pamela’s New Workout, by sending a CC message to the Mother 32, which then sends it to PNW.
I set up an infinite ghost trigger with the maximum CC value, but the default state is 0. While everything seems to work fine during sequence playback, when I press stop (even multiple times), PNW keeps running and I have to stop it manually.
It appears that the CC value is not resetting to zero, and I can only stop PNW by slightly moving the CC knob.
Do you have any ideas on how to fix this issue?
I’d try this : Set 0 as default track value and double stop (triple while playing). It should send value 0. Plock other values.
1 Like
other
3
This is my workflow – and it does not reset to zero until I turn the knob to the left 
Ah ok sorry, I didn’t interpreted as double stop. Could you check with a midi monitor if default values are sent with double stop ?
other
5
Ok, for some reason, after a double stop Octatrack is sending CC1 with 127 value
I can’t see CC1 (ModWheel).
I can see Channel Volume, which is CC7 (normally), sent on channel 1.
Is your midi track set to channel 1 ? Midi tracks channels have to be different from audio tracks channels (Trig Ch, set in MIDI > CONTROL, you can set them to off for tests)
other
7
For some reason changing CC1 value is read as Channel Volume by Midi Monitor
I’ve made a clean project to check it once again. All Adudio tracks Midi is set to off.
Did you set CC1 value 127 on a midi track set to channel 16 ?
I won’t be able to try this week.
other
9
Yes – I’ve tested in on other channels and it was set t o16.
So if midi track CC1 value is 127, it seems normal…
other
11
But the default value is 0 – and after stop it’s sending 127 again.
1 Like
