I’m new to making music with electronic instruments so bear with me. I suspect there’s a simple solution to my issue.
I recently purchased a DT, a DN, a keystep and some MIDI cables. I’m currently in the process of setting everything up so that I can make compositions with them. If I’m not mistaken, I think I have the MIDI cables set up properly. In order to verify if that’s correct I’m trying to control the DN with the DT via the keystep. So far I have not been able to accomplish this. I’m not 100% sure if I have the MIDI channel I intend to route a sound from the DN to set up properly, and I’m also not sure if the audio from the DN will send audio through to the DT; I currently have a pair of headphones connected to the DT. Will I need another audio cable connected to the DN going into my headphones to hear sounds triggered by the DT from the DN, or should I be able to hear sounds from the DN through my headphones connected to the DT permitting my MIDI cables and settings are set up properly?
Any insight is highly appreciated.
There are many ways to do this. This way is mine.
DN has the midi clock!
The DN midi thru goes to the DT for the Midi clock.
The DN midi out goes to the KS Midi in
The KS midi out goes to the DN midi in
The KS has dip switches on the back, set these to sync from Midi clock in.
Set the KS Midi Out to Midi Thru in the KS control center software.
Press Play button on KS to get arps and sequences.
Now with this setup the KS is always locked in perfect sync with the DN bpm.
The arp and sequencer on the KS have a division setting to change the speed
1 Like
Thank you for your reply. I’m fairly certain that I’ve set all of that up successfully. My question is more in regards to whether I need to run the DT and the DN through a mixer or something like that. For whatever reason I was under the impression that once all of this was set up properly that I could just have my headphones connected to the DT and I’d hear both the DN and the DT through the headphones. Do I need to send both their audio into a mixer and have my headphones connected to the mixer instead of the DT? Or should I be able to hear the DT and the DN through the headphone jack of my DT?
You have to connect audio out of the DN to something either thru a mixer or monitoring thru the DT
But to be honest get mixer:wink:
1 Like
Midi cables do not carry audio.
If you want to use only the headphone jack for audio, You will get the best results routing the audio l/r out of the the dt into the audio inputs on the dn so you can apply the dn effects on the dt as it passes thru. Then you would be able to hear both machines out of the dn headphone jack.
2 Likes
Thanks a lot for both of your replies. Being the total noob that I am with regards to this stuff, your thoughtful responses are highly appreciated.
I’m actually headed to my local music store right now for unrelated reasons, but I may as well pick up whatever I need while I’m there. Should I just grab some audio cables and a mixer? I assume that’s probably the optimal way to go.
As @jefones tried to explain: for listening with headphones route the audio the other way around, from the DT main out to the DN in.
The reason for this: the DN is much more capable for treating audio in. It supports stereo and can apply its effects on the incoming audio. So the DN can be used as fully functional mixer for another device (like the DT in your case).
The DT on the other hand doesn’t allow stereo monitoring. So its quite restricted for your use case.
IMHO its not really necessary to get a mixer when you are just using these two devices.
2 Likes