Pattern Synchronization between Rytm and Analog 4

Elektron Gear Analog Rytm
1

Hello,

so i have a Question about the Synchronization between Patterns on two Elektron devices.
First, i set up all the Functions in both devices. Rytm is the Master and A4 is the Slave.

When i change Pattern A 1 to A 2 in the Rytm - so it Synchronized the A 4, the Analog Four changes the Pattern like the Rytm from A 1 to A 2. Everything works fine …

But !! If the Pattern changes, it is not in Time.
So when i press A 1 to A 2 at the Rytm, the Pattern in the Analog Four, needs a little bit more Time to change from A 1 - to A2.

I looked at the Pattern behavior, Direct Jump, Direct Start etc. but it is still there, a latency. Anyone a Solution, for that Problem??

Thank You very much!

2

Is this happening trying to use direct jump on the Rytm end where you expect then both machines to change right when you press the trig, or are you using sequential change on the Rytm and expecting both machines play on the next bar?
I think I’ve heard that only the latter works well and the first scenario may not behave correctly, possible bug…

3

Are you master pattern lengths set correctly?

2 Likes