daje
Anyone not able to record the FX send in Logic using multi-outs? Seem to remember that being DT 10, now I’m not getting anything in that channel.
I am. You gotta route that out too.
Through audio routing in DT? I have 9/9 sends going to FX - a little confused what I’m missing
(I think it’s 10) but do you have audio no.10 routes out? I believe 10 of 10 on the DT is FX audio track.
I’m getting 10 mono outputs in Logic, just not getting anything in channel 10, even though I’m using lots of reverb 
Have you checked Overbridge configuration app to make sure it’s enabled? It’s possible that you just need to hit apply for input 10.
No, that‘s the monitoring for the inputs. @voicemagic track 10 is not the fx track. To record the fx separately you have to change the Audio routing so that none of the audio tracks are being sent to the main outs, then the main outs will have the fx, while you can record the audio tracks on their own channels
nice…I was trying to respond blind. I totally forget. 
right so perhaps he wasn’t getting FX [tried on the Digitone]…yes FX come out 1-2 [on my machine 23-24] but I had to have SYN2, FLTR and AMP or any combination of to have whatever was getting routed through those to come out. all 3 sounds like the full FX. perhaps those were not getting sent to MAIN?
On the Digitone hardware go to audio routing- route to main- change this to 3/7 (the main is now fx only). Then send the main out on the Overbridge track in Logic to a bus, then route an audio track to that bus. You can now record fx.