1

Hey there!
I have been trying for a while to get the Program Change message sent from the Octatrack to switch patterns on the Norand Mono MK1.
The goal is to have each part linked to a different pattern on the Norand Mono, so when I switch parts, I want the associated pattern to change too. I would like to use the Mono’s sequencer with the stored patterns.

I have tried various settings but none seem to work.
The most sensible settings seem to me:

Octatrack Midi Out --> Norand Mono Midi In
Octratrack settings: Transport Send, Clock Send, Program Change Send Channel 1, Midi Setup Channel 1, Bank Off, Prog 0-12 (for testing purpose), SBank off.
Norand Mono settings: Midi Channel 1, Midi Clock Receive.

I feel like I’m missing something since the transport works fine and also Midi notes entered into the Octatrack Sequencer get interpreted by the Mono. I can assign CCs for example for the filter as well and they work. This is why I think the Midi Channels are set up correctly. The program change message that changes patterns on the Mono however is not. I think that the PC-message only gets sent when I change patterns on the Octatrack so I did that, but it doesn’t work. I feel that maybe I need to set up the “Bank” and “Sbank” parameters in the Octatrack in a specific way, but so far, everythink I’ve tried failed to work.

So, long story short: Does anyone use the Norand Mono with pattern change from the Octatrack and maybe help me troubleshoot?

2

You’re probably right with that. Does the manual of the mono say anything about it?

3

well it says that the mono changes pattern with external program change messages:
Mono supports program change to switch pattern, send a program change between 0 and 63 to set the current pattern. Note that play mode will affect the behavior just as it would if you switch pattern manually.

4

Does setting ‘Bank 0’ and ‘Prog 1’ on the midi note Page of the OT do anything?
If not try:
‘SBNK 0’ and ‘Prog 1’

Depending on weither or not the Mono listens to MSB or LSB, either one should work.

Otherwise I have no idea, since I don’t know the Mono.

5

Update:
The problem was a bug introduced somewhere between firmware 1.xxx and 2.0
Since I have installed firmware 2.1.0 the problem went away and the settings in my post above for the Octatrack are correct.

I did read the patchnotes but this bug was not mentioned so I figured it must be something else…

2 Likes