No midi learn from monomachine

onoma · 2014-09-16T13:18:12.000Z

So I perform the following steps:

[ul]
[li]octatrack to mnm as a master, (with 2 midi-cables)[/li]
[li]enable CC DIRECT CONNECT [/li]
[li]go to CC1-10[/li]
[li]Press F+Knob to get “turn knob on the device” message[/li]
[/ul]

Then i proceed to turn some monomachine knobs but OT doesn’t pick this up. The message stays on screen.

When i enter CC number manually (picking one from the MnM chart) it works: i can see mnm parameter movement and record it to OT.

I don’t have other midi devices to check if the problem is on mnm or OT side.

What am i doing wrong?

Castor · 2019-03-25T11:17:55.540Z

i have the same problem. can someone help please?

onoma · 2019-03-26T12:05:41.348Z

There is a setting in MNM(Control Out 2 i beleive) where you can pick Encoder Destination. Pick Int+Ext

Castor · 2019-03-27T19:50:03.697Z

onoma:

There is a setting in MNM(Control Out 2 i beleive) where you can pick Encoder Destination. Pick Int+Ext

Are you sure? There’s no such option on my MnM mk2+

jefones · 2019-03-27T19:56:10.761Z

202D198C-696B-47B9-B78C-C779B919C27F.png640×1136 123 KB

This is what the above poster is referencing. It is definitely on the mkii.

Castor · 2019-03-27T20:45:05.417Z

ah that!

it works! thnx!