1

So I perform the following steps:

[ul]
[li]octatrack to mnm as a master, (with 2 midi-cables)[/li]
[li]enable CC DIRECT CONNECT [/li]
[li]go to CC1-10[/li]
[li]Press F+Knob to get “turn knob on the device” message[/li]
[/ul]

Then i proceed to turn some monomachine knobs but OT doesn’t pick this up. The message stays on screen.

When i enter CC number manually (picking one from the MnM chart) it works: i can see mnm parameter movement and record it to OT.

I don’t have other midi devices to check if the problem is on mnm or OT side.

What am i doing wrong?

2

i have the same problem. can someone help please?

3

There is a setting in MNM(Control Out 2 i beleive) where you can pick Encoder Destination. Pick Int+Ext

1 Like
4

Are you sure? There’s no such option on my MnM mk2+

5

image
202D198C-696B-47B9-B78C-C779B919C27F.png640×1136 123 KB

This is what the above poster is referencing. It is definitely on the mkii.

3 Likes
6

ah that! :man_facepalming:

it works! thnx! :thup:

2 Likes