Hi Elektronauts,
I have recently purchased a DT for it’s amazing sequencing power as a compliment to my SP404SX. I would like to sequence some one-shots that was sampled in the SP thru the DT. However, I could not trigger the sample on my SP. I was using midi channel A on DT and midi ch. 1 on SP.
Current setup:
DT: Midi out
SP: Midi in
DT: Audio out
SP: Audio in (ext. on)
Is there something I am missing while preparing for the midi-sync?
Thanks in advance!
Make sure midi channel1 and track A are one in the same.
Edit and isn’t there a point where some of the samples are actually routed to the consecutive midi track
Edit again: push the encoder for track 1. At that point it should show you what midi channel it’s routed to. It can be routed from 1-16. And can even be p-locked per step
Just a little tip also I believe the SP’s note values start from B, not C. That always threw me off using it with the DT or Circuit. Also, make sure that midi track A is also set to midi channel 1.
on Midi channel A did you check if its sending midi in the SRC page? If the CHAN box has an X you need to press Func+Press encoder to enable.
Thanks everyone for the input, it is working for me now! Excited to dive deep in the Digi-realm.