Machine Drum + Mega Command + MIDI

florbit · 2023-02-05T13:57:14.431Z

Does anyone know if its possible to sequence and external device (eurorack) with the machine drum while its connect to the mega command .

Thanks

waftlord · 2023-02-05T22:00:38.178Z

you could use impulse from the MDs CDEF outputs, or midi from mcl

florbit · 2023-02-05T23:53:21.575Z

Thanks. So could I use a MIDI machine on the MD x0.7 send midi to the MC and then out from MC to my MIDI to CV converter?

waftlord · 2023-02-06T09:42:07.191Z

no, currently MID machines are not available when in enhanced mode.

MCLs 6 midi tracks are intended for the purpose you’re after.

Synthpatic · 2025-03-07T17:00:55.467Z

How can i use them? I want to use some of the external sewuencers of the mcl but i couldnt find out how. I was reading the manual but its not giving lots of info.

waftlord · 2025-03-07T17:31:13.460Z

MCL 4.60 enabled the MID machines again. So you have both options.

Synthpatic · 2025-03-07T18:26:02.444Z

Ok but how do i use the ones in the mcl? The manual was not helpfull. Is there something like a more advanced manual for the mcl? I know the old way wirh the midmashines but i dont wanna use a machine for that. Right niw i do my external midi sewuencing with my analog keys. 2 of my ak channels are used for that. But if possible i would like to use the mcl to control 2 midi channels i send tonmy eurorack.

waftlord · 2025-03-07T21:52:34.166Z

You can do all this.
There is a bit of routing and midi setup to do.

Synthpatic · 2025-03-08T06:19:52.298Z

How theidi routing works is covered in the manual. My question is how do i access the external miditracks.

Synthpatic · 2025-03-09T10:04:13.579Z

Found a newer manual where its covered. Still i got some priblems with the y grid i will probably stop using it and just connect my analog keys for the keyboard. When i make changes in the y grid it doenst appear on the sequencer of my analog keys. Should it be like that or should the ak sequencer show the information from the y grid.