Is the Model:Samples the thing I need?

I’m not an expert in these things (in case you hadn’t worked that out already) but the samples are coming from audio clips in Ableton at 48k, exporting as a wav at 48k and then transferring onto the AR using Elektron Transfer.

The audio clips sound identical inside and outside of Ableton when listening on my macbook (I listen to them with Quicktime/iTunes to check I’ve exported the right track etc), but by the time they reach the AR they sound pretty crappy. I’m probably being a bit unfair with crappy but it’s certainly not good.

I’ve checked all my settings for filters, master compression etc, but nothing really makes a massive difference, so I’m assuming what I’m hearing is simply the difference between digital stereo and analog mono.

The model:samples awaits for me at home when I finish work so I’ll give that a whirl and see what it sounds like. Cheers!

So since the AR plays back mono samples, it’s combining left and right signals into one mono signal. When that happens, there’s a decent chance what you are hearing is phase cancelation of lower frequencies.

Now, the model:samples is the same so if this happens on that, too, try creating your sounds in mono to begin with to avoid this from happening.

1 Like

In Ableton, use the Utility plugin to make each sample mono. If it sounds rubbish there, it’ll be the same in whatever mono sampler you’re using. If that’s the case, remove things like reverb, chorus etc then add it back in on Rytm (well, no chorus, but delay and reverb are stereo). If you absolutely must retain the stereo imaging from your sound, it is possible to use two channels on AR to receive a live stereo signal over USB – could be worth looking up if all else fails.

Thanks Craig, I tried that and I would say it sounds almost as crappy as the AR when played in mono in its original state in Ableton.

I also tried the same strings sample on the model:samples and it sounded absolutely identical (to my ear at least) as when played through the analog filters of the AR. So I think it’s purely the stereo/mono issue that’s causing the sound degradation, rather than the analog filters of the AR.

Thanks for your help everyone. Blackbox 1010 here I come.

1 Like

In utility you could try using only the right or left channel ( whichever sounds better for you), export that and see if that mono version is satisfying for you, when used in the AR or MS.

1 Like

One thing to check (it might have changed since I owned one) Blackbox only allowed 16 samples per project, you can get around it by using slice chains though, but it was a bit of a limitation for me, it might not be the case anymore but could be worth looking into if that might be an issue for you.