Hi there
I 'm quiet stuck with the strange behavior of the amp.
on 2 flex machines, using exactly the same set up , I get two different behavior.
on one flex, everything seems to work perfectly, on the other one, the enveloppe parameters don’t seem to affect anything…
any idea ?
thanks
Paulie
Sounds odd. I think you´ll need provide more details though in order for us being able to help you further.
ok thanks
what kind of details would you need ?
Go to your first flex machine track.
Go to the Amp page.
Write down all six or whatever values. Post them here.
Repeat above with 2nd flex track.
Sometimes the scene parameters take over the track parameter: did you set some amp parameters on a scene?
ok
@Drone -> no p-locks on scene anywhere
@governor -> same settings on both Amps and Playback settings
amp: anlg sync :off att: lin
fx1 : anlg fx2 : anlg
loop: off slice: off len: off
Rate: pitch tstr: off
on the first slot I can’t seem to alter hold or release
whereas I can on the second one…
I’m not a super octatrack user, but not a noob either, producing a lot with it, giging with it…but what’s going on here is just a mystery to me…and the octa is such a vast territory…
Make sure you do not have a Track LFO assigned to any of the Amp parameters.
done…no lfo assigned…still no change.
is there any chance that arrangement automation would do that ?
is so, can I reset it to default ?
up
Have you tried copying the working track and pasting over the non-working track?
Also try muting the scenes as well as disabling plocks on them. I had a similar problem yesterday which turned out to be scene related.
check your MIDI control settings (Project > MIDI > Control)
if AUDIO CC OUT is set to EXT, knobs won’t affect parameters
ALSO
make sure your audio tracks are not set to the same MIDI channel as a MIDI sequencer track. otherwise, knobs won’t affect THAT track, even though the knobs will work on other tracks.
i think that’s what was happening to OP