Goldbaby Dirt and Layers

[kilroy.was]

Hi! I have recently purchased a pack from Goldbaby called Dirt and Layers. He suggests to add these noises (vinyl, tape, stomp boxes etc.) to drums, layer them on top or below. It’s pretty clear how to do this in Ableton, but not sure about Elektron (I’m still a beginner sampler). If not the DT but perhaps the Octatrack has a workaround?

[Claid]

This is the best sample pack available on the internet, in my opinion.

On any sampler that can’t play more than one sample on a track at once, you’ll need to play one sample on one track and one on another, and resample to get them both together.

[kilroy.was]

Or tweak them on Mac and then add the pre-layered sample?

[Clancy]

It’s a good sample pack

Trick to get 2 layers combined in one sample but keeping the relative levels adjustable (PAN becomes a crossfader between eg. a kick and a dirt layer)

Using two sound on the same trig line?

You can have two samples sounding on the same trig, same track. You put them on the left & right channels. Use spatialiser with M/S on and mid gain down. Then plock the pan to control their relative levels, or control it with the crossfader, or even use the trigs-nudged-up-close trick and use conditional. Good for kick/snare/both economising

[Claid]

This is what I would do, however OP wanted to know how to do it on the OT.

@Using two sound on the same trig line?

You can have two samples sounding on the same trig, same track. You put them on the left & right channels. Use spatialiser with M/S on and mid gain down. Then plock the pan to control their relative levels, or control it with the crossfader, or even use the trigs-nudged-up-close trick and use conditional. Good for kick/snare/both economising

This is genius and much better than my suggestion.